Product Description Description: F250 (250脳250mm) direct forming to square pipe mill/tube mill is used to produce square pipe of 100脳100mm-250脳250mm and 3.0mm-10.0mm in wall thickness, from square or rectangular to square or rectangular pipe directly. F100 direct forming line for square and rectangular tube, can carry out the forming change operation in a very short time and without any replacement of rolls, reduce the roll input about 60%. This equipment presents a great innovation compared to the past because the DIRECT FORMING SYSTEM is applied to any part of the production line: FORMING 鈥?WELDING 鈥?SIZING 鈥揝TRAIGHTENING. The line set up is totally automatic. Moreover, the square or rectangular shaping is directly carried out before the tube welding, with important advantages in terms of power and material cost reduction. Characteristic锛?/strong> 路One set mold roller can produces a range of rectangular tubes. 路This machine has characteristics such as no replace spindle, no remove roller stand and quick change rollers. 路Save mold, save time. 路Four square corner deformation part which can save extra deformation process then save energy consumption and equipment load. Direct Forming to square tube mill advantage: 1. Lower production cost: 5% raw material saving 2. Very Precise control of the corner radius 3. Frequent production changes without a roll change: possibility to produce small lots of final products 4. Mature design 5. Very Fast changeover 6. Reduced investment: no requirement for different types of rolls and additional floor space for roll storage 7. Very High automation level: minimized operator tuning Specification Finished product Square & rectangular Tube 100脳100mm-250脳250mm 100脳120mm-250脳300mm Thickness: 2.0mm-8.0mm Length5m-12m Length Tolerance卤3.0mm Production SpeedMax 35 m/minChina Direct Forming To Square Pipe Mill suppliers website:http://www.weldedpipemill.com/direct-forming-to-square-pipe-mill/